Would like a quote on an exhaust housing please...

Extended Power

Extended Power

New member
Looking for a ceramic coated, or stainless steel housing.

-It is for a Borg Warner S300: 64/71/.70 (My existing turbo)

-I am looking for a divided .80 wastegated exhaust housing, with a V-band exit.

PM if preferred.

Thanks!
 
Coated housing

A coated housing is a very good way to go. It is cheaper by far and is better at heat reflection. I am guessing 350-400. Shane or Brandon can quote you exactly on the price. The stainless housings have been cracking. If you do coatings inside and out side you will never see any cracking. I have not seen any coated housing crack that was coated in and out. Thanks
 
Last edited:
Thanks.
I just picked up the housing yesterday, and looked at it today...the inlet ports look very small.
I am going to get this one coated inside and out with a titanium finish. (Supposed to be good for over 2000*F) But the color is an army green color.
Getting the S480 coated with a "High Luster" ceramic, inside, and out, that is good for 1200*F.
The hot piping will be done in the 2000*F stuff...the rest will be done in the High luster ceramic.
 

Attachments

  • IMGP0591 (Medium).JPG
    IMGP0591 (Medium).JPG
    46.7 KB · Views: 0
  • IMGP0592 (Medium).JPG
    IMGP0592 (Medium).JPG
    41.1 KB · Views: 0
  • IMGP0593 (Medium).JPG
    IMGP0593 (Medium).JPG
    51.1 KB · Views: 0
  • IMG_0289 (Medium).JPG
    IMG_0289 (Medium).JPG
    57.9 KB · Views: 0
You must log in or register to reply here.
Back
Top