My Latest hooks.. getting better

Good looking runs House! Don't have any reason for the heat in the motor and spinning out at the end.
 
werent you going to change out your A/W intercooler for a bigger unit?

Garrett
 
I was till broke an axle shaft, I then bought HMR axles instead of bigger a/w
 
no idea, never had pump benched was told it was putting out 580 from previous owner
 
Too much fuel, turbine housing is too tight. What timing, injector cone angle, and piston?
 
Last edited:
28 timing, 5x25 edms from schied no idea on angle stock pistons.. I tried a s478 with 83 turbine and 1.10 and never could get on top of it before i bought the turbo thats on it now,
 
You had too much fuel for that charger also. Bit too much timing for that piston if they are stock angle pattern wise.
 
house said:
28 timing, 5x25 edms from schied no idea on angle stock pistons.. I tried a s478 with 83 turbine and 1.10 and never could get on top of it before i bought the turbo thats on it now,
Click to expand...

also 4.88 gears and 4th low leave line at 4900 and run 3500 down track
 
Mine has been running better every pass the more fuel i take out of. Just a thought
 
You must log in or register to reply here.
Back
Top