Recent content by 04dirtymax

anyone on here ever tried one, it screws on your factory filter head and allows you to use a 2micron cat filter

well i took my dash apart to try to change my blown dashlights, only to find they are not serviceable, when i put the dash back in the speedo needle and rpm needle fell out of place, i put them back in at 0 but when i re installed it and drove the truck the speedo fell down below the 0 and the...

my dads truck has four bad injectors "3,4,6,8" and he is going to go ahead and change all 8, where is the best place to get injectors from, also what kind of upgraded nozzles should he go with to benefit future mods?

from 80 i can floor it and i make 30+ boost like normal, but the truck goes no where fast and my egts are through the roof 1200 plus? any ideas as to what this is caused by? maybe my stock mouth piece? thanks!

i'm looking to upgrade from my stock turbo and make the most power possible with the stock injectors and cp3. which is better big single or twins? "i need something i can do in my garage" any suggestions??

I recently took my truck to the shop for an alignment and found out I need inner and outer tie rod ends, upper ball joints, pitman arm, and idler arm, I want to beef up the front end, any ideas on braces or after market tie rods i should use? any ideas are appreciated, thanks!

http://www.youtube.com/watch?v=cjQ369ku_Jo

will my stock internals be able to handle a small shot of nitrous? i hear rods bend around 550-600 hp, i have no clue what im making now but im sure its close to 450

when i boost up my truck in 4hi to about 10lbs and let out the brake and into the throttle i've been popping a fuse labeled "1*" any ideas as to what it may be?

when i try to log with my efilive a message pops up that says i need to change the scan mode to "stream fast" or "dynamic" in order to log, i do so and it still pops up with the same message anyone know whats goin on?

just got my lift pump installed but there are no instructions on how to adjust the pressure do i just turn it all the way up?

just blew a head gasket in my 04 lly, is this something im guna need to take to the shop or can a average joe do this in the garage?

i just installed the swith on my 04 lly when i cranked the truck it says the battery isn't charging and i have low oil pressure what could of caused this, i appreciate any help

What is the most power you can make with efi live without going into the motor or messing with the stock cp3 and injectors?

can someone explain exactly what efi is and how i can get it, i just sold my ppe and the truck is slow....