Recent content by 6point6

I will also look at any interestesting trades. Pm me what you have. Never know what I might do. 93 Mustang GT - It has 120,000 miles on the body and only 10K on a forged 302 and Tremec T3550. The car has just been painted black and looks great. It has new headlights, new front bumper cover...

I'm installing it on my 06 and just want to make sure I'm getting the wires right on the sensors. Crankshaft sensor - white wire connected to the wire towards the front of the truck (crank sensor is sideways with the wires in a line. I put it on the front wire) (I'm getting a 61 rpm reading...

I'm installing it on my 06 and just want to make sure I'm getting the wires right on the sensors. Crankshaft sensor - white wire connected to the wire towards the front of the truck (crank sensor is sideways with the wires in a line. I put it on the front wire) (I'm getting a 61 rpm reading...

Well guys I'm pulling in our school's truck pull thursday night and have all of the mods in my sig. Any advice like 4 hi or 4 lo.....Leave it in drive? I also have 6" DR blocks in the rear do any of yall pull with lift blocks?

Well guys the frog sent me a tune that will hold 31-34 psi and when I was driving about 80 down I75 I got on it and it pegged at 44 psi of boost! I know that is way too much for the turbo so we're going to turn it down a little bit but the most I had seen out of my file from sct and innovative...

Tell me what yall think....It's dirty and the pics were taken at night time but I'll get some good one's tomorow!

Hey Guys, The college I'm going to is a big agricultural college and has an annual truck pull every fall. What are some tips for pulling and I had thought about getting a nitrous kit put on my truck for the strip would I be able to spray it while pulling? Thanks for any input yall can give me...

Hey Guys....I ordered a Superlift 6" for my 06 with the bilstein shocks. I am looking at getting these wheels and tires from a guy. The wheels are 22X9.5 Alba Gripp's with 37/13.50 Mud Grapplers on them. Here's two pics. I've heard the mud grapplers are noisy but ride great....Is it not...

Just what the title says! Thanks Guys!!!

Well guys I found out from Doug A.k.A psdplayer that the job 2 trucks that have the YJZO processor code will not run correctly with the SCT because injection timing and boost are off for certain in the map. Doug has contacted SCT and they are working on the problem. I thought this was a neat bit...

What yall think?!? :ylsuper:

Hey guys, I was just sent over by dennis @ ts. He said there would be alot of names that I recognized and it's true! Is this the new "site" or will everyone be staying around both places?? Again, great looking site and seems to have alot of promise!