I recently puchased a 10 cummins with a smeding diesel 2nd gen turbo swap with a s467. Turbo compressor wheel looks like it went through a blender. Question is does anyone sell just a wheel so I can just rebuild it and put it back together or am I going to have to buy a whole cartridge?
Looking for some parts for a 2.5 truck. Looking for a good p7100 preferably a 13mm, a dual or triple disk clutch for nv4500, and a good 2.5 charger has to be t4 because of mstpa rules.
Putting a Detroit true trac in my Dana 80. Anyone have any specs as far as carrier preload pinion preload depth, backlash I need all of it....Long story short some mouron pulled it all apart and didn't thing to check anything
Putting my engine together, just pickup my new head. Measured piston potrusion so looks like I'm going to be opting for a .010 over head gasket. Question is what gasket are you supposed to use for a o-ringed 24v head. Pure diesel sells a modified marine 12v gasket to use with a oringed 24v head...
Putting my engine together, just pickup my new head. Measured piston potrusion so looks like I'm going to be opting for a .010 over head gasket. Question is what gasket are you supposed to use for a o-ringed 24v head. Pure diesel sells a modified marine 12v gasket to use with a oringed 24v head...
In need of a good or rebuild able cylinder head need ASAP have paypal ready, would like Orings and port and polish but stock is fine also let me know what you got
Ok engine in the fummins is getting taken back down,so starting to make up a build sheet,goal for truck is mean street machine and going to see quite a bit of track time 500-600 hp
Question is what are your experiences with bearing coatings
Been thinking h series clevite bearings with calico...