Recent content by AcIdBuRn02ZTS

  1. A

    Internal WG Help - Compounded 4bt

    Hey guys... Trying to slowly but surely work out the bugs in my build and at the moment, I think my current wastegate plumbing is holding me back. Setup as follows... 120hp VE pump 4bt 6cm hx30w (high pressure) 12cm wh1c (atmosphere) wastegate disabled. Currently, the hx30w is getting its...
  2. A

    E4OD woes...

    Hey guys... Got an old '93 f250 4x4 ext. cab with the 7.3 idi. Lately the trans has been acting up a bit. The truck is stock and has 255k on the odometer.. its a work truck and has been used as such. A few weeks back, we had 3k# of block in the bed for a short drive (12 miles or so...)...
  3. A

    Idle misfire cause possibly found.. Injector crush washer in pieces??

    Hey guys.. Ive been dealing with issues on my 4bt for a month or so now.. I had noticed a very light misfire at idle and just off idle that seemed to go away once rpm picked up... Then my ve pump started leaking between the case and head.. After getting that fixed and replumbing the feed...
  4. A

    VE Pump Help?!?

    Hey guys... Sorry if this is in the wrong spot, but couldn't really find a good area for the questions. Ive got a 4bta swapped into an '03 Tahoe... its compounded, etc..etc.. Recently the ve pump started leaking so I decided to do a reseal on it. Pulled it apart and went through it...
  5. A

    WH1C Rebuild question?

    Hey guys... I picked up a "good" used wh1c from a local for a small compound setup on my 4bt. I noticed when I picked it up that it had a bit of play but I couldn't see any rub marks nor could I feel any drag when pushing on the wheel... well I have it home and pulled it apart and there is...
  6. A

    2003 Z71 Tahoe - Cummins 4bta Swap

    Hey guys... I put a lot of pictures from my swap in my intro but didn't notice this section of the forum... so I figured I would go on and make a complete build thread on it. What started this whole project is seeing a Jeep Scrambler at the Indy 4-wheel drive jamboree that had a 4bt dropped...
  7. A

    New guy from Southern, IN

    Hey alls... I've got an '03 Z71 Tahoe... I am just finishing my 4bt-a Cummins swap.. truck is driveable and runs good... Need to get a few electrical bugs worked out but other then that I'm happy with it so far. I just finished building a 4l80e with help from Jakes Performance for it and...
See more
Back
Top