Recent content by agamache

Looking for a 24v to put in a 04 ford

Was wondering if I needed to invest in a regulated return kit if i was only planing on going 150hp over stock and factory injectors :thankyou2:

After 8 to 10 hours of sit time (let engine cool down overnight) should there still be pressure on the system. I thought as the temp went of coolant went down the pressure would go down also. Coolant down to outside temp, no pressure. thanks

Has anyone used the the non synthetic version of this with good results Thanks

got my coolant filtration system installed. How long was it before your first filter plugged up

anybody's boot look this bad

i have a 2004 f250 ext cab and was wanting to know if i needed the f350 flat blocks or tapered or if it wouldn't make a difference. I installed a leveling kit about 3 months ago and the front it still higher than the rear thank for the advice

About 3 months ago i put a rough country leveling kit (leaf springs) on my truck. After i installed it i noticed the front was sit higher than the back and i figured the new springs need a little settling time, but as stated it has been 3 to months and the front is still higher. Has anyone had...

Hello all I am planning on getting an sct x3 with x race tune (running edge with att now). My question is if get and air dog and a fuel line crossover , would this be enough to supply all the. Fuel I need and not run injector out of fuel

If an injecter fails will u get a code or a cel

I have been wanting to do the ccv mod to my truck for awhile now and was wondering if it is better to spend the money for a kit or is it something i can do and not harm to the engine

Has anyone ran Mobil 1 synthetic rear diff fluid. if so do u remember if the friction additive was needed

I was wondering if anyone is running one of the egr cooler upgrade, if you like/or not, and how long you have been running it. I am trying to keep it factory because i still have warranty left(extended). Thank you for your opinions and insight :thankyou2:

Hello everyone

I was wondering was is needed to be done to 6.0 to get close to 500 hp and ft lbs of torque. I don't have a lot done to my truck just a 4 1/2 in turbo back exhaust. The egr is unplugged and waiting for the block off plate to come. I am going to get it studded in the near future and get rid if...