Recent content by Blueboy

New never out of the package. Rons machine service,complete master install kit. RK AAM11.5-A $150 plus shipping

I bought 1" coil drop springs for front of my truck from Spring Specialties. 2500 2wd, cost over $300 plus shipping. Had them on my truck for a month, decided to go lower. These are still like new. $100 plus shipping.

I have P2509, P2609, I had P0514, I was able to clear that one. The other ones wont clear. I know what the codes are! I have new batteries. My problem is when truck sets for a week it will discharge. I have taken every wire off and cleaned. I know it sounds like a short, but I can't find it. My...

I live in Webster NY. Early this morning a man that lives on Lake Rd in Webster, set his house on fire. Three houses next to his caught on fire also. Two of the houses belonged to a friend of mine. These houses are on the bay side, he walked across the street on the lake side. Lake Ontario. Hid...

I will be moving both rear shocks to back of axle. Anyone that has done this, how did you space them. stock space, closer, or further apart.

I have a gasket leak on bottom plate that holds injector wires. Will it come out with just pulling wires off injectors. 05 dodge.

I am going to install a VIBRANT E-VAC Kit in my down pipe. I'm looking at a Parker CV Check valve to use with this, they come in 5 to 65 psi, what pressure will work for this.

On my 05 I switched to a 2nd gen ss manifold. My turbo is a 475, There is a lot of weight hanging on that v band clamp with exhaust piping. Has anyone that has done this swap, braced their down pipe.

will a set of 98 vp rockers work on my cr.

New in the box, Hamilton 110lb valve springs. $290 shipped.

I just received a price for Shot peening a set of 24v rods. $500 does this sound right.

I matched ported the t4 manifold and turbo on my truck now. I just received my new stainless diesel manifold, the ports are smaller then on my turbo, going by gasket. Are the any reason to port this.

What is the opening on the front cover of a s475 turbo,4" or 5".

I just bought 02 going to sell 98. 3 weeks ago lost water pump, put new water pump and timing belt. Everything works on car, no cel,s. car passed inspection in April. The body is shot, upper body is not bad, it,s underneath. I still drive car everyday. Car is in Webster NY. $1200 firm.

I have a crank at Moldex crankshafts. They are going to magnaflux, check for straightness, bullnose knife edge, polish, balance. Which would be the better way to go. Nitriding, heat treat, or cryo.