Recent content by bluextc

  1. bluextc

    2011 3500 cranking issues

    I have a 2011 3500 and I changed out the motor and now it will not start with the key. I can hold the key in the crank position and it turns over five times and stops for a couple of seconds then spins five more times. It does that as long as you hold the key in the crank position. It will start...
  2. bluextc

    24V crankshaft

    I am looking for a good standard 24V Crankshaft. It would be great if it was near the Memphis, Tn. area. Thanks
  3. bluextc

    TPS issues

    I have some issues and I am hoping someone has some answers. Ya'll usually do, thank goodness. I have an '02 3500 and when you are driving it will have a dead pedal and sets a code that says the apps and map voltage does not match. It also has low power when it starts doing this. The motor is...
  4. bluextc

    PCS trans controller

    PCS transmission controller and wiring for a 5R110 trans. pulled it out and went a different direction with truck. I don't need it sitting around here. someone needs this. $750 or best offer.
  5. bluextc

    NV4500 trans and transfer case

    I have a NV4500 trans and transfer case out of my 98 3500 dodge for sale. 3rd gear syncronizer scratches a little. Trans, transfer case, shifter, flywheel and clutch, cross member. I have not pulled out the pedal assembly but it can go with it also if needed. $1500.00 obo I would rather not ship.
  6. bluextc

    4094 Turbo

    I pulled the turbo off of my 05' when I got hit and I don't need it now. I would like to sell it and I have a MBRP down pipe and the AFE intake mouth piece that goes with it. It has roughly 5000 miles on it. It ran awesome and sounded good. I am asking $2000 OBO. I hope somebody needs it or...
  7. bluextc

    '07 6.7L turbo help

    Hey everyone. I need some help and/or opinions. I have a friend that is wanting to put twin turbos on his mega cab. He wants a major horse power and pulling power but I think he just needs big towing power. I am looking for a good twin kit and who might be the best company to buy from. Please...
  8. bluextc

    06 Ford w/06 Cummins A/C issues

    Hello everyone. I have been building this truck for sometime and I drive it a good bit. I finally started finishing the A/C system and I have a odd problem. This is a 2006 F350 with a 2006 Cummins and I am using the 5R110 trans with PCS controller and it all works great. When I have it...
  9. bluextc

    2004 Excursion

    2004 Excursion with 159,236 miles. It has had an EGR cooler delete installed. It has had a little lady drive it since it was new and she is tired of the size and wants to sell it since she has no ne to carry around except herself. We are fixing the ignition switch and the I can be exact with the...
  10. bluextc

    06 2500 parts

    I've got an '06 2500 crew cab 4wheel drive truck that has been rolled and I pulled the motor out and put it in a ford. I have a few of the parts for sale. G56 trans Front and rear axles Passenger front fender I will look Monday and see if there is any other body parts not damaged and see what...
  11. bluextc

    '06 6.0L will not run! Help

    Ok gentlemen I am in great need here. I have an '06 6.0 F-350 and it was cut off and never ran again. Where to start? FICM voltage is 47.5volts. ICP runs on up to 1800 once it hit 500. IPR starts out at 15 and goes to 85 after it spins a few seconds. Injectors are new. Fuel pressure is 60 psi...
  12. bluextc

    6.0L & 7.3L motors for sale

    I have two 6.0L motors one is a long block core motor and one is all apart with 120,000 miles. The long block is an '03 and the other one is an '05. I have a complete 7.3L 2001 with 80,000 miles that has a lot of blowby. These are basically core motors and someone else needs them besides me...
  13. bluextc

    ladder bars

    has anyone ever had ladder bars on the front end and if so who made them? I have spring wrap in the front end and I am not sure how to correct it so I am looking for some help. Thanks Eddie
  14. bluextc

    Monticello,Arkansas Truck Pull June 26,2010

    Chester's Xtreme Diesel out of Eudora,Ark. has put together several sponsors like River City Turbo , Zeb's Welding & Machine and a bunch more. It is going to be at Hwy 425 Mud Track in Monticello,Ark. south of Little Rock. Chester said they are constantly adding money to the payout and they are...
  15. bluextc

    Midsouth Diesel Pullers date change for Covington,Tn.

    Midsouth Diesel Pullers May 29 date has been cancelled by the arena board of directors and they apologize for any inconvience it may have caused us or anyone else. We are looking for feedback on June 5 being a good date for everyone. That is the following weekend. Please let us know if that is...
Back
Top