Recent content by bubba2400

F106 third member. Welded carrier, bolt kit, 6.20 gears. $300 262-417-6541

For sale is a Second Gen Dodge Dana 60 front axle. I have everything to convert to a free hub setup except for the outer axle shafts and lock outs. I have both inner axle shafts, hubs, spindles, new bearings and seals. I have a 35 spline Powr Lok carrier for 4.56 and up gears if someone is...

Brand new rocker panels that I ordered for my 96 extended cab truck and never used. Ask any questions you have, 262-417-6541 $100 shipped lower 48 states.

Have a 12 valve motor that was put in a 96 Ford. The motor had an ATI Super Damper on it. Problem is the crank pulley that is behind the damper rubs the front cover where the two oil pan bolts thread in just slightly. Seems to get worse when the motor warms up (go figure). Since this motor...

All of the badges off of a 2013 Ram 2500 with a cummins. Basically everything that was on the doors and the front fender. These have zero street miles. I had the dealer take them off before I picked up the truck. I think I have the Big Horn tailgate emblem too, that will go with the package...

Just picked my new one up Monday. Have 75 miles on it so far. Crew Cab short box, 370/800 motor in it. Nice truck so far. When should the first oil change on the motor and trans be done? I want this thing to last for a while and willing to take the time to take care of it.

Runs and drives great. Transmission shifts decent, not a lot of history on it. The filter and fluid just changed on it. 3rd gen adjustable trac bar installed. Fresh alignment on the front end. New batteries, air filter, brake controller, u-joints, sway bar end links, front cover seal...

370 Marine injectors as far as I know from the numbers on the injectors (7596, 59P14 688 17, 7597 on the tip). Bought a truck with these in it. Truck ran good but I do not need these in it. $275 shipped to the lower 48.

Can anyone help to identify these injectors. The numbers on them are 7596, 59P14 688 17. Suppose to be II pieces but not for sure. They hazed while at idle and made it smoke pretty good on the top end. Thanks

Looking for one or a set of front dually simulators for a 2nd gen Dodge. I have one side already but will buy a set if needed. Let me know what you have. Call/text/email Two Six Two - 417-654one james@bigdodgehitch.com Thanks

Looking to trade for a stock exhaust, or just something quiet. This is a complete exhaust, turbo back, is on an extended cab long box dually. In good condition, don't know what brand it is. Let me know what you have.

Good guy to deal with, worked with me and held the truck for a couple weeks until I could pick it up. Thanks to him once again.

For sale is a Panasonic Gunslinger 260 MIG welder. 220 volt single phase. Can weld up to 1/2" material. Comes with .035" and .045" drive rollers. Has always worked great. $900 Call with any questions 262-417-6541

For sale is a Dana 60 yoke from an 02 Dodge front axle. 1350 joint. In good condition. I will run a tap through the holes to clean them up before sending it out. $30 plus the ride. Call or email 262-417-6541 james@bigchevyhitch.com

I have a Dana 60 open carrier out of an 02 Dodge front axle. Had 4.10 gears on it when taken out. Has 32 spline side gears. $75 obo 262-417-6541