Recent content by cummin get it

Billet rear freeze plug for 98.5-02 cummins-$40 Heavy duty hydraulics for clutch from South bend clutch-$250 South bend comp 3850 dual disk clutch. Has the comp disks. Probably needs freshened up before installing. Comes with bearing and arm.-$400 Stock manifold and turbo off a 2006...

Wanting to purchase a block. Are there any available used?

Apparently .120 ss lines are out of stock everywhere. Anyone have 1 line laying around unbent they are willing to sell? 32" length

I need another cam gear for a strictly pulling only 2001 p pump 24v dodge ram. Let me know what you have thank you.

I have a PDI 3 piece exhaust manifold painted red with a T-3 to T-4 adapter on it in the pic. Will sell as a whole or split manifold and adaptor. Manifold-300 With adaptor-350 Adaptor-50 Cam 188-210 cam 360 lift. Still has 24v cam gear on it with retainer. 550 with gear and retainer 400 just...

Got a little bit of a project going on. I noticed some studs got damaged over the years I had them in the garage. I need (3) arp's 12 mm 425 head studs with nut and washer, (1) 12 mm ARP main stud extra long with the girdle spacer that has a flat spot on the back, and the washer and nut for that...

I am going 13mm no longer need these items. Mikes stage 2 monster VP pump. Run for two seasons. Always had 20 psi fed to it. $1,400 plus ride. Air dog 200 lift pump. Run for two seasons. Note this is not a new pump that had mother failures. This pump was run for two season prior to my two...

I've seen the link floating around here before but can't remember what the website was called. So if someone knows where I can buy reasonably priced 3" tubing, v band clamps, and flanges; that would be great :)

Anyone got a number or link to order one of these manifolds?

Kit# 4955305RX Assy#4045752 Serial# 1709282 These are the numbers on the compressor housing. Off a Cummins according to the tag.

Truck details. 02 dodge 6 speed 3600 sbdd Super phat shaft 66 .80 t3 over billet bullseye s480 .90 t4 Sovp44 8x.011 sticks Smarty Drag comp Fass 150 Studs 110 springs Afe intake and intake elbow 4" exhaust no muff Would the enternal wastegate on the 66 be enough or does it need an external...

I can't remember what the average factory clutch holds for horsepower is it 300-350. Maybe 350-400?

Looking for a good used wheel and housing for my s400 T4. I have a 1.0a/r housing and wheel I'd be will to trade as well. Ill have to measure it can't remember the turbine size but its from a s475 charger.

Have a monster 2 vp this is a pull truck. Have a code p0253 which is fuel injection pump fuel valve open circuit. Any idea how to solve issue or does the pump need sent in? Cleaned the plug on injection pump worked for about 30 feet then back to this half power bs. Any advice is appreciated thanks.

Currently running 6x.020 built by Weston but they are almost clearing out. What you got?