Recent content by Great White

1998 Dodge Ram 2500 12v Cummins I have owned this truck for about 8 years. I drove the truck as a daily for 2-3 years until it was no longer practical. I've raced the truck in super diesel class and sled pulled with it for a few years taking home 1st place many times. The truck has...

Has anyone attended this pull before? Just wondering if anyone was planning on competing and what to expect for a turnout? Im debating on trying to make it out to this event or Hollister on 10/1 and wondering which one would be worth going out to. Thanks

There will be a diesel dyno event on April 30 in Camarillo California. The dyno is a dyno jet 224 xlc rated to 2000hp. Their should be a good turnout and trucks putting down some impressive numbers. Address: 19 aviador st. unit E Camarillo, CA 93010 Event will start at 9:00 am

Anyone going out to vegas next weekend? Im really hoping there is a good turnout this year! This will be the first time my truck will run the 1/4 with my setup running half way descent.. hopefully we'll see some good numbers up on the board. :bow:

I know the tps has a signal going to the Gov on the trans and being a potentiameter I figured it was needed to send the correct voltage to the trans... I am trying to wire the truck up right now without using a pcm(I can't find one anywhere) and I just want to make sure everything is right this...

I need a pcm for a 1998 12v auto 4x4. part # 56040034AA please call me at 8057949951 thanks

Hey all, Ive been fighting many problems over the years and im hoping its finally coming to an end here. I just installed tranny number 7... and im checking to make sure everything is good to go. The previous owner of the truck did some hokey sh!& with the wiring so I went ahead and rewired...

Anyone coming out this year? 2008 there was a pretty good number of trucks running, last year not so much. Hope to see you guys out there

Its been almost a year since this has been goin on, It all started when my pump went out. So far ive put a scheid HO pump, fass, MAP sensor, injectors and the dang thing is still surging! No codes are showing. A couple symptoms are it only does it when it gets up to temp, idle is at 1000rpm when...

Hi, I just swaped my first vp44. Its a schied high output pump. I got the pump inline with the gear(double checked) everything seems to be hooked up fine no leakes got it primed. When I first start it, it idles fine but as soon I give it the slightest fuel it raises the idle and from there when...

Hey I was wondering if anyone knew off hand If 3rd generation front controll arms will fit on my 2nd generation? Thanks