Recent content by Harris

I have a 2010 Cummins has following mods: Air- 366/484 firepunk kit Fuel- S&S 300% ATS Dual pumps FASS Tuning- EFI from Hardway Trans- 48 swap with Anteater Exhaust- 4 inch down pipe to 5 inch straight I keep getting the P2281 code Leak between MAF and throttle body. I...

I bought a used 2010 that currently hasan electric fan, and I would like to switch back to factory clutch fan for towing since the electric will not keep engine cool. So I am looking for the fan shroud, mounts, and fan. Sent from my iPhone using Tapatalk

My 07 with ppe dual fuelers is maxing rail pressure 26k at idle and has a code for high rail pressure. Where should I start FCA's, ECM, or PPE controller for pumps? The fuse for the PPE controller is good and everything is plugged it. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I split one of the silicon boots on my intercooler just wondering if anyone recommended any good places or brands to replace mine with?

Well guys this is my first post i usually figure out my problems by reading old post but this one has got me:doh: With engine cold it runs normal but once the engine gets to operating temp it derates an will only make around 14kthe rail pressure while derared and it doesnt give me any code's...