Recent content by Kroner96

Shafts are in good shape with no twists or worn splines. They measure 37 1/2" and 38 3/4". They include drive hubs and axle bolt covers. I'm not sure of brand but can send pictures. $450 shipped

Selling the 5.9 Cummins out of my pulling 3.0 truck. Filled encore block Aftermarket girdle that ties into the mains Schied billet front cover with covers for cam and pump gear. Adjustable pump gear Modified vacuum pump to run waterman fuel pump. Waterman pump not included Fluidampner with...

Went to odl setup and no longer need these. Branik axle shafts from a drw Dana 80. They are in good shape and come with drive hubs and bolt covers. $700 241 dhd transfercase with the big output shaft for a nv4500. Tailshaft housing has been repaired and could use a reseal but has no problems...

Went with a different setup and don't need it anymore. $350

dana 80 dually axle out of my pulling truck. It has the following 37 spline branik axle shafts Spool Girdled cover with inspection hole and snub bolts 1480 yoke Has a lot of bracing welded to it for extra strength All bearings were new in 15 and it sat all of last season. It still has disc...

Rockwell slhd axle out of a 9500 gmc. It has the same carrier as an sqhd and would be good for pulling. The axle has 4.11 gears and is complete with rims. $500 located in Evansville In

I'm looking to narrow the track width on a 91 d350 by about 7". The plan is to eventually drop a 49 Chevy body on it. I'm trying to do it all with the control arms and the rim offset. Anyone ever tried anything simmilar or have any ideas?

I picked these up in a trade but have no use for them. They measure 22x9.5 and use the 8x170 bolt pattern. Located in southern Indiana. Asking $400 obo. Text for pictures 1 812 457-6710

Looking for a dhd with the big output shaft and for a nv4500. The closer to southern Indiana the better. Pm, call, or text. 812 457 6710

Not a complete kit but it doesn't need much to be finished. I was making a nice set of towing twins but had some things come up. Includes 12cm housing with a spring actuator and the gate opened to 35mm. Ht3b with 22cm housing Hot pipe Cold pipe Intercooler pipe. Needs finished 5" exhaust...

Pull is at the vanderburgh co fair grounds off of highway 41. Pull starts at 6pm with 3 sleds going at once. $5 to get in and $1000 payout for 2.6. If anyone is interested in the tractor classes shoot me a pm on here. Hope to see a lot of you guys there.

Srw Dana 80 from my 1996 Dodge. It has drum brakes and comes with brake lines and e brake cables. I had 4.88 gears and a spool installed, made one pull then upgraded to a bigger axle to run duals. Located in southern Indiana $1000 obo. 812 457-6710

Upgraded to a bigger turbo so this one is for sale. Compressor is 66mm x 98mm. The exhaust housing is a 241. It's a T4 charger and comes with the downpipe. $700

6.7 block and crank for sale. Engine was going to be rebuilt but ended up using a whole new engine. Has some surface rust on the crank from sitting. Needs cleaned up but is in good shape. $900 for both, local pickup only. Parts are in southern Indiana. I can text pics if interested. Thanks

I need a driveshaft for my 99 dodge. Let me know what you have.