Recent content by rollingthunder

I bought a motor fresh from the machine shop. Previous owner was putting it together to race /pull and had the machine shop hone on the looser side. I will be using it for my daily drive. Right now the bores are at 4.0197 - 4.0204 24 valve pistons are around 4.0118??? That would leave me...

Off a 99 auto. Was a running truck when pulled for a p pump swap $400 shipped. Also open to trades (24 valve manifold, turbos, studs..... Have money to throw on top as well) Sent from my SM-G930P using Tapatalk

Have a 45k mile he351ve with stock manifold (6.7) with block off plates. Also have a t3 to t4i adapter if you want to use you existing manifold. And steed techs controller (new version with USB and calibration ability) I have only used it on the bench to calibrate the actuator to confirm it...

Set of 5x13's with less than 200 miles on them. $350 no cores needed Sent from my SM-G930P using Tapatalk

Have p pump related parts off a95 dodge auto truck. I heard the motor run before pulling the motor but already had a benched p pump so used that when I swapped motors. It's a 160 pump with 180k miles. Had 181 dvs, 4k gsk, rack plug installed by Anarundel performance. All brackets, hardware...

Cables about 18 months old..... Little different setup than the dodge cable Sent from my Nexus 6P using Tapatalk

Looking for a little direction of what to check on the truck. It's a 05 Ford with a 12 valve and the 5r. The motor had 140k on it and ran good when pulled out of the dodge. I tore it down, changed rings(still had good factory cross hatch) main, rod, and cam bearings. Had the head gonr...

Just seeing if anyone has a used aftermarket pin for a ve pump laying around . Got a buddy in Honduras who picked up a 93 ford with a 12 valve and mounted a well drilling rig on it. E are looking to add a little fuel and some rpms to help with the mountains. Thanks Sent from my Nexus 6P...

Off a 95. Previous owner said he replaced the TPS about 6k miles before he wrecked the truck. Includes some new ball/studs for the rod. $100 shipped Ibo Sent from my Nexus 6P using Tapatalk

3" pusher intake with 2 ports for 12 valve. $100 Sent from my Nexus 6P using Tapatalk

Have a ram computer mount for a Ford superduty. I know it fits 05-07 not sure on others. It's a no drill install... Bolts under the two mounts on the passenger seat. $150+ shipping. Sent from my Nexus 6P using Tapatalk

Swapped a 12 valve into my 05 so don't need this anymore. I bought the ficm used with 4k miles on it, used it for one year(12k) miles. $200 + shipping Egr delete with stainless up pipe, not sure on the brand, Marty's diesel installed it . $50 + sh Sent from my Nexus 6P using Tapatalk

I bought a motor that had a set of 5x14 injectors built by Arundel diesel and performance in severn md. I have a receipt from the install on 8/29/15. It was wrecked a couple months later and I got the motor out of it. Not sure on miles but it shouldn't be much for the short while the truck was...

Set of 167 dv's from a 95 160 pump with 140k. $80 shipped

Doesn't need this on the pump for the swap into my superduty. Not sure what it's worth do make an offer