Recent content by Southpawslingr1

My signature is accurate to my current truck. So to start off I have a low grumble that starts at like 50 MPH. At around 63 it starts to get very noticeable, between 68 and 73 its a very high frequency vibration that you can feel in your seat and the floor. At 73 it is gone completely. The truck...

I have a 2000 cummins with 99 motor in it. It currently has large unknown to me injectors with 350-rr inscribed on the bodies. I am installing a little super b for towing. I would like to trade the large injectors in the truck and a stock set of nozzles for either 75 or 90 horse injectors. The...

Ok to start off I have quite a few upgrades including a modded FCA, CP3, and rail. All of these parts are built by T&C diesel. I recently moved from NY to summit county Colorado. So from 1500 feet of elevation to 9500 feet. Im getting the expected freight train smoke from elevation. As soon as...

So I smoked my clutch last night pulling. Looking for opinions/price on triple disks.

So we just replaced my crossover tubes due to the fact that at wot I was only seeing 12 kpsi at wot. I spoke with Todd from T&C and he suspected leaking tubes. We followed the instructions on his page for the install. I'm still seeing around 12 kpsi at wot. I also have much more pronounced...

Local fair time! Running about 700ish HP manual tranny. The track is a horse arena they do not water it. Between passes it get basically York raked. I'm running copper AT3s. Any ideas on tire pressure? It will most likely be soft crappy dirt. I run 1 inch suspension limiters. I'm thinking as far...

So I have all the MODS listed in my sig. I just had to upgrade my smarty from TNT R to the new POD. I was having issues with the truck and had my ECM completely reset. Anyway I put catcher #7 in. I have not messed with any other options. The truck is running decent but im not seeing the power I...

Ive been trying to figure this out for months now. I installed my compound turbos, Flux 3s, maxspool cam, head studs, valve springs, push rods, coolant bypass, and arson cp3. It was quite the adventure getting everything together but thats a story for a different day. The truck runs like a raped...

This is going to be a long post so please bear with me. I have a 2005 2500 four wheel drive G56. when I bought the truck it had a FASS stacks and pyro and boost gauges. Almost immediately i bought a smarty senior for it. I had three years of good trouble free power at that level. Of course I...

I just installed most of the "enhancements" in my sig. I currently have pyro and boost. I would like to add fuel pressure and rail pressure. I have the white face red needle green back light gauges to match my truck. Question is where can I find these two gauges in the right range for my truck...