Recent content by Tony R

Started about 2 months ago. It would do it once every couple of weeks. Would be driving along and it would just die. I push the clutch in wait till the rpms hit 0 and it fires right back up. There other morning I was going to work and it died at the stoplight. I would restart and it would die...

I got a call from buddy the other night who attempted to put some 4K springs in his sons truck. He said he was having issues with the truck not wanting to idle and if you put it in gear, even holding the rpms up to 1500 it would stall. I told him a couple things to try like adding a couple...

I’m looking for a stock hx35 for a 12v manual truck and a 4” downpipe. Let me know if you got something.

I'm looking for a compressor wheel and a rebuild kit for a s4t. It seems every place I have tried, I have struck out. Tried Columbus diesel and industrial and forced induction with no luck. Can anybody point me in the right direction.

Truck is a 86 gmc with a in the 70's 1 ton driveline and frame under it. Not sure if it's a 305 or 350. It has a newer edelbrock 4 barrel and has headers. I swapped it over to a sm465 and it pops out of 3rd gear like the rest of them do. It has a loadtrail flatbed with a gooseneck hitch. I have...

I got a 2001 Ford F-250 crew cab short bed 4x4 lariat automatic 7.3 powerstoke. It has around 320,000 on it and the motor has about 200,000 on it. It is rusty, the rocker on the drivers side is shot, along with the cab corners and wheel wells on the bed. It has a ts performance 6 position...

Looking for a compressor wheel and shaft for a s4t. Nothing fancy stock is fine.

I got a 91 gallon rds toolbox/ fuel tank combo. It's in decent shape, not perfect but decent. Could use a good clean up and a couple new lid shocks. This is the type to use as a auxiliary tank in your truck. Located in Beaver Ohio 45613. 475.00 Obo.

Looking for a 2wd sm465. Actually the auto went out of my firewood truck and I want to do a manual swap. Hopefully somebody has something close to southern ohio.

1996 Dodge Eclb 4x4 I built this for a local stock Driveline/unlimited charger class, I don't have the time or the desire to pull trucks anymore. The body has a new paint job which dosen't match as you can see in the pictures.The cab and doors are rust free, the bed does have the usual holes for...

I filled up the coolant system, in the motor I just rebuilt. I noticed I have coolant dripping from the oil cooler. It is coming out of the adapter that goes from the oil cooler to the flywheel housing. I understand what I have to do to remove it, but my question is, why is it leaking? I used a...

Are some of the bellhousing bolts studs? Do these go toward the top of the bellhousing and are used to hold the dipstick in place. I apoligize for being so ignorant about all this. This use to be a pulling truck and the original owner wants it back to stock. When I took on the job the motor was...

Looking for a part number for a coolant temp sensor for a 02 lb7 my plug in is round, not oval like everything else I'm finding.

Humor me here but when does the engine wiring harness go on the engine. It's been 18 months since I took it apart and can't remember for the life of me. Does it go on after I install the center bridge between the intakes and before I install the fuel lines from the cp3 to the rails, or after...

Hey guys I was wondering if anyone had both of the crankshaft seal Installers, I can borrow for a couple of days. I will pay for shipping both ways and a case 24/30 pack of your favorite drink.