Search results

I was reading my National Dragster magazine and noticed a big write-up about the Schied rail. Very impressive to get into the NHRA mainstream media. :clap:

What are the actual specs of the 87/81 "J-type" Borg Warner turbine wheel? The info I found shows a measurement of 87.37/81.74mm. I recently purchased a new S475 and specifically asked for the 87/81 "J-type" Borg Warner turbine wheel. The measurements on my wheel are 87.30/80.38mm. What...

I am assuming this is a tuning issue and have possibly missed a limiter somewhere. Speed limiter is maxed out. Over 110mph @ WOT my fuel psi will start spiking up and down. If i ease into it say 1/4 to 1/2 throttle it pulls through past 120mph. I have attached a log it starts on frame...

Looking to buy a twin scroll T3.85 A/R turbine housing for a S300 with a 68 turbine and a HX40 outlet.

Is this a good quality kit or should I use someone else? My 48RE is due for a rebuild and I am considering the Suncoast 48RE M3GA kit. I have used their kits on Allisons with good results just not sure about the 48Re kit. The truck is a tow rig/daily driver 450-500hp.

Any of our vendors in the OK/TX area balance turbos? My HE351cw gave out, I bought the parts to repair the turbo and need to have it balanced, thanks.

I have a 2006 5.9 cummins, FASS lift pump, and EFI. I just changed crossover tubes (6.7 style) coper washers, o-rings, and ARP studs for injector hold downs because I had a leaking tube. After I got everything done the truck starts but acts like it is in limp mode. No smoke, no rough idle...

I need to find a shop with a torque plate for a 2006 5.9 cummins. I am having the cylinders bored .020 over and going with ARP 625 head studs. I have called several shops from Lawton to Tulsa with no luck. Several shops can do the work, but do not have a plate or know anyone who has a plate...

I live in Clarksville, TN. Came to this site to learn what people are doing to their diesels. Looks like a good site.