Search results

I put in a transgo shift kit. I keep turning line pressure up. I like the way it shifts and drives with more pressure. Im at 140, 160 in od cold oil. I have upgraded strut and anchor. Mark at transgo told me high line pressure will damage thrust bearings in engine. Is this true? and how high can...

I found some tci instructions, It shows drilling out a hole to 7/64. Anyone drill this hole out?http://www.jegs.com/InstallationInstructions/800/890/890-220500.pdf

Hey guy I installed the shift kit in my 93w250. Now trans feels sloppy and shifts into 3rd gear and or maybe od when shift lever is in second. When it shifts out of second feels real loose It would never shift out of second gear when I had shift lever in 2nd before shift kit. Truck is only...

Live in hesperia ca looking for a A518 4x4 trans that is rebuildable or that works thanks Dave.

Is it safe to mill the valve spring pads down 0.100 . Is water close or do they crack?

looking for a rebuildable core. or a stocker.

Im going to the wrecking yard to find a 47rh. How do i identify trans? Is there any tags or casting numbers to look for? whats a good price for a core?

How much piston to valve clearence do in need? Is a bronze cam thrust plate a good upgrade? Im gonna run billet oring freeze plugs on side and a bypass plug in rear of block. Should i worry about popping front plug? Im gonna run be running a belt.

anyone use there pump gear or billet freeze plugs? or do business with them? JDs Diesel Performance

looking for preferably a 17 but anythings better than the 22 i have.

i heard to re torque 4 times before you run engine with studs to get stretch out. and then a hot re torque.

heard some good thing about them. anyone run them?

anyone use these springs on 12v?. they fit the spring pocket and there install hieght is .050 less than stock. i saw a lift spring pressure chart on 60lb springs some where anyone have a link?

anyone using sb chevy intake or ex valves springs or retainers? what size stems? or valve dia intake or ex. was thinking about 1.840 intake not sure on ex. maybe undercut stems on intake. manley makes some 5/16 also

bought 2 rods from him paypal delivered in few days with tracking number thanks

what do you guys know about hx50 turbos. such as diffrent turbine wheel sizes or compressor wheel sizes. need some part numbers, im looking for one with a 17cm turbine.

anyone have a good used crankshaft in california. im 2 1/2 hrs from vegas. trying to save on shipping

is it ok to cryo treat your products?

anyone cryoed any parts? does dimensions change after treating do you have to re-machine clearances? like block decks or main bearing saddles?

anyone run one?