Search results

Looking for a woodgrain dash bezel. For a 99 to 02 2ed gen dodge. Must be I. Good shape. No cracks or broken tabs.

I tried the search function. And it didn't show anything which is weird because I've read about the 53 block a lot. And I can't remember, if when you look on the drivers side by the power steering pump, and under the vp in the spot it just shows a series of numbers. But no 53 around there. Does...

I was searching all over for this and couldn't find a thing. Has anyone replaced the green light ring. That is around the ignition key? I was wondering About how that comes out. And Is it a pain to do? Thanks

Hey. I got a bone stock 2001 dodge cummins. And while driving the tach fell to 0. And the check engine light came on. And drove for a mile or so and the tach started working again. Any ideas? I read where it could be cam sensor. No when the tach stopped that was the only problem. Truck ran fine...

Question is am I leaving the tq locked too long? Normally I lock it at the 100 ft and leave it locked till the end. Well this year I put a triple disc converter in it. Last year I ran a double disc. And always ran to end with it locked. What the truck is doing is it gets close to the end of the...

Ok so it's the truck in the sig. The 98. I keep getting a p0622 code. Generator field not switching properly. I just had trans work done. And also new reman PCM/ECM. What would cause this. Never had this code until I pulled and trans wouldn't shift. But you can clear code and trucks fine. Then...

I had to get a new ECM and PCM. My question is I have smarty download in it. Can I just take the truck back to stock, pull the smarty out. Then put new ECM in, and reload it once the new ones in and be fine? And how do I unlock the smarty. Never had to do it before. Thanks

I'm lookin to upgrade injectors for the truck in the signature the 98. Right now it has 100 horse intergrity injectors. With a stock reman vp and Airdog. I'd like to go little bit bigger for sled pulling and very little street driving. What do you guys recommend? Also has a built hx 40 turbo.

So pulled two different places over the weekend, 2 hooks at each place. the first pull truck ran great. the three others, it had like a slight miss after take off, (kinda like it wasnt getting fuel) but by like 130 mark or so it would smooth out and run fine. ended up pulling 290's and 300's.so...

Hey everybody, I have been browsing the site for few months finally joined. Lotta good info and helpfull people here. My names Rob i got a 1998 Dodge 2500. I use it for pretty much everything DD and sled pulling a little bit. Pulling trailers. Just no snow plowing with it.

Ok guys, This year i changed a few things. I added edge comp box w/ hot. Still using smarty i stacked the two, turned the hx 35 turbo into an hx40 w/ billet compesser wheel and shaft and bigger exhaust side. And also added lock up switch for trans. So my questions r which settings work good for...