2011 with BBi 1.5's

BrianAtSmarty

BrianAtSmarty

SmartyResource
Joined
Aug 13, 2012
Messages
432
2011 with BBi 1.5's



We are ready to get some dyno numbers with the BBi 1.5s on our "11".
We dynoed today with a Smarty SR and did a run of 534 and 535. Stock CP-3 and stock Stix. 2nd gen conversion small frame 400, 75 compressor, .83 turbine wheel and a .9 housing. Also a stock lift pump.

This truck has the G-56 6 speed manual and 315 tires. Southbend 3250 d/d.

Tomorrow we torque head, install the BBi 1.5's, adjust valves, and if we have time get some dyno runs in.



Brian
SmartyResource--Home
 
We got the sticks in today and got er on the rollers. We need to increase fuel delivery. Stock LP doesn't cut it. Seemed to run out of fuel before 3,000 RPM. Got a run of 607 and 612.

Going to stick a FASS on it and retest. Then try an 85% over CP-3.

We will see what tomorrow might bring!
 
Time for an update. Here is where we are at this time.

2011, 6spd., dual disc clutch, stripped, 2nd gen conversion with a s400. 75/83/.9

3.42 gears & 34" tires

Smarty Sr.

544hp, 2nd run 545hp

Added BBi1.5's

607 and 612! Runs out of fuel well below 3000 rpm. 52 psi boost, 52 psi drive and 1550 degrees

Added FASS

627 and 628 and just over 1300 ft lbs

added 85% over pump

701/1386 and 704/1391
 
^^^ dork!

You have no idea what your talking about. Go ahead and wait another decade till you get it.

UDC rocks.
 
You must log in or register to reply here.
Back
Top