Dana 80 C&C question

[a24vc]

I have searched quite a bit this morning and have not come up with much. Running a Cab and chassis dana 80, can you use a SRW? I believe the axle is 2 inches narrower than the SRW 80. It seems ok to me, just looking for some confirmation or to see if anyone else has done this. :woohoo:

 

[zstroken]

What do you mean can you use an SRW? If you mean can you run SRW rims on it and not use duals the answer is yes.

 

[a24vc]

That was the question. I wanted to make sure that there was enough clearance between inner fender/springs.

 

[zstroken]

That was the question. I wanted to make sure that there was enough clearance between inner fender/springs.

Depends on backspacing of the wheel, but I think unless you get one that is way out there, it should be fine.

 

[Tate]

I doubt you will find an SRW rim that has more backspacing than a dually rim on the inside. Maybe if it were 16" wide.

 

[1-5-3-6-2-4]

I originally ran custom offset rims on my cab and chassis diffs to make the SRW track width the same.

Sent from my HTC Desire HD A9191 using Tapatalk 2