Bad Mannerz
Hooker with Bad Mannerz
- Joined
- May 5, 2010
- Messages
- 79
I have a stock full width FDS 75 front steer axle complete with knuckles, hubs, and factory warn lockouts.
TRB Machine equal length moly inner and out shafts with wing flange joints, drive flanges, drive flange billet aluminum cover plates, and detroit locker.
This setup will allow you to cut the long side tube to equal the short side tube and put the pumpkin in the center.
No expense was spared on these parts.
All of the shaft parts are new and have never been installed. Scrapped the build and am selling off all my pulling parts.
$5000 shipped. I will pallet everything and ship to the address requested.
Disregard the 106 on the left. I had to purchase it as well to get the front. The FDS 75 for sale is on the right.
Call Brandon 804 647 7540
TRB Machine equal length moly inner and out shafts with wing flange joints, drive flanges, drive flange billet aluminum cover plates, and detroit locker.
This setup will allow you to cut the long side tube to equal the short side tube and put the pumpkin in the center.
No expense was spared on these parts.
All of the shaft parts are new and have never been installed. Scrapped the build and am selling off all my pulling parts.
$5000 shipped. I will pallet everything and ship to the address requested.
Disregard the 106 on the left. I had to purchase it as well to get the front. The FDS 75 for sale is on the right.
Call Brandon 804 647 7540