How to remove Speed Limiter on '06

[Ultimate Diesel]

Does anyone have a solution to remove the speed limiter on the '06 Cummins? Other than reprogramming the ABS to smaller tire size. I need to remove it all together. I've talked to BD and ATS and they do not have solutions for this issue.:thankyou2:

 

[Morse]

I'd like a permanent solution as well...

 

[BrettWINspeed]

It would be tough to do while racing, but you can hold the key to the start position and it should bypass the limiter. It won't activate the starter because of the neutral safety switch.

 

[Ultimate Diesel]

That does not work on the 2006. That was the first thing we tried. But, I figured it out. Simple Solution.

 

[Reb.B]

its easy, just cut the ABS wire (green or green with red stripe?) and put a switch in between. I cut it below the fuse box.

 

[WUnderwood]

the BD top speed eliminator works well

 

[Burner]

Does the speedo still work with the BD?

 

[Timbeaux]

Nope...it overides the sensor

 

[Ultimate Diesel]

BD Unit does not work on 06. Only 03-05

 

[Reb.B]

the BD does not work on 06 because of the CAN BUSS setup. On the 03-05 trucks its works like a zenier diode. It takes voltage up to 90 mph and drops the rest off to ground. So the MGH will hit 90 and stay but the truck keeps on going

 

[TEXASPOWER]

i just take the fuseout but if have on the fly 4x4 the nob wont work

 

[Burner]

Can this not be 'over ridden' by a programmer or some type of flash?

 

[RascalMafia]

does anyone have anymore specs on the zener that bd uses? like where it goes and which diode it is exactly?