ppump oil feed

[cumminsgrunt]

I know by switching the oil feed to the drivers side of the pump you need to buy a restrictor so it wont flood the gov spring area with too much oil. my question is cant you just take the oil line fitting off the pass. side and put it in the drivers side port. the oil fitting looks no different then this restrictor fitting ya need.

 

[GOT-Torque]

The restriction is cast into the pump body within the hole the factory fitting screws into (you will see it when you remove the stock fitting). The factory fitting doesn't restrict the oil flow.

 

[cumminsgrunt]

thanks, i went back and looked and saw that its cast into the pump.

 

[MOPSD250]

There was a write up someone took the plug drilled a .064 hole thru the center of the plug then drilled and tapped the plug for 1/8npt fitting. Idk if you wanna go that way but I did read on here someone did it.I did it and worked pretty good

 

[HOSE_B]

bosch make a fitting that give you the room to run a 1/8 npt fitting in the factory spot got mine from goff diesel injection murray utah 801-288-9222 talk to scott hope this helps

 

[91shelbydaytona]

I bought my restrictor fitting from eatsoot.com for like 10 bucks :Cheer:

 

[01smoker]

x2. Jesse makes alot of cool stuff.

 

[91shelbydaytona]

P-pump oil inlet fitting - JDs Diesel Performance