Recentering H1 wheels.

S

SsgBulldawg

New member
Hey brothers and sisters. I have all my parts in to recenter h1 wheels and was wondering if anyone else has done it. Id like to see pics of a 6.4 with them on it. All i can look up is the older trucks.
 
What was your runout? Twf says theyre runout is .0003 i figured .0005-.001 would be suffice obviously if i can get them closer the better
 
Mine was 0.015-0.030 on three of them, the fourth for whatever reason I couldn't get any better than ~0.100.

I'm sure the truer the better. I think OEM wheels run-out was sometimes up to .050-.080 or something like that.


Sent from my iPhone using Tapatalk
 
I looked up D.O.T. regs on semi steel wheels and the tolerance is .070 laterand radial and on autos its .100 later and radial. i got one of mine at .010 (took 30 min to get it there)and about 3 around .030 and the last couldnt get better than .070.
 
I do have some vibs but my driveshaft isn't balanced. It's coming off this weekend to get balanced and then I'll report. I'm just running air soft pellets in the tires. The vibs are only at certain speeds also.

Also I should note that te tires I have right now are worn out bad and un-even wear. They were free until I determine if I like the setup.


Sent from my iPhone using Tapatalk
 
Ahh alright. Jus got em done
c23afa94a24604f63f91e799e4ddfcf4.jpg

Nice wide and penitrated welds
1ed4fda0981e0fd75c213f0b73fb8652.jpg

Knocked the studs out to hit it with a wire wheel
e8629b0ed8d1c3b24a1cda44336a8ba4.jpg

when i get done blasting the outer rings and painting it all ill post pics of the bolted up
 
I had twf do mine before they shipped. I ran beads in 1 and liquid in the other for balancing. Needed 50+ in weights for each if I was to use weights. Had no problem with beads and liquid.
 
madmikeismad said:
I had twf do mine before they shipped. I ran beads in 1 and liquid in the other for balancing. Needed 50+ in weights for each if I was to use weights. Had no problem with beads and liquid.
Click to expand...


How much weight in beads?

OP, you welded the whole perimeter? I just ran stitch weld for fear of warping.


Sent from my iPhone using Tapatalk
 
Ghostman said:
How much weight in beads?

OP, you welded the whole perimeter? I just ran stitch weld for fear of warping.


Sent from my iPhone using Tapatalk
Click to expand...

I can't remember. I think just threw in 2X oz just to be safe, didn't really measure. Same for the liquid, which I know for sure was less than 20oz. It was so conventient not having to spin the tire and add weight every time. Just pull the valve, add the stuff, and go.
 
Yeah I only put in 10oz beads. I think it just needs more personally.


Sent from my iPhone using Tapatalk
 
I tacked them up on yhe truck and took them to a race car fab guy amd he welded them. They stayed true so im not too worried. This is the spare. Im going to take it up to the shop and see what the balance is. This one had more tacks in it from alligning on the truck.
954aaf3c1d99a7afc9922fb2fc8acef7.jpg
 
You must log in or register to reply here.
Back
Top