Powdercoat injection lines

fordcummins1992

boost guy

• Jul 4, 2019

• #1

Anyone ever sandblast and powdercoat their ugly dirty lines

Sent from my SM-G950W using Tapatalk

 

CorneliusRox

Seasoned Rookie

• Jul 8, 2019

• #2

Lots have. You have to be very careful you don't get sand inside the line (kills injectors), or under the nut (makes lines crack over time).

 

Timbeaux

Administrator and Head Thread Derailer

• Jul 8, 2019

• #3

CorneliusRox said:

Lots have. You have to be very careful you don't get sand inside the line (kills injectors), or under the nut (makes lines crack over time).

Click to expand...

This.



You have to be quite meticulous.

 

79powerwagon

New member

• Jul 8, 2019

• #4

Never PCd any but i like to save old quill(crossover tubes) to thread into each end for painting/handling

 

thatguy69

New member

• Jul 8, 2019

• #5

I sandblasted and painted mine, didn't powder coat though. Don't spray to much powder on the part of the nut the wrench slips on, it's already a tight fit. And i know powder oat is more durable than regular paint but I'm sure it'll still chip

 

R

Redrider2911

New member

• Jul 8, 2019

• #6

I was wondering if ceramicoat would be a better option for stuff like this?...

 

D

Dart340w2

New member

• Jul 8, 2019

• #7

I went to a local place (EPI plating) that does different types of bolt coatings, zinc plating, etc. I had a few bolts re coated as well. I took the lines to a different place to have media blasted first and it wasn’t cheap. I am very happy with the results.