Moser engineering in Portland, In.
"Stubby" My 10 second Street/drag truck build
- Thread starter Macktruckdriver
- Start date
Moser engineering in Portland, In.
Macktruckdriver
New member
Finally had time to work on my compounds.
straight 6 roar
New member
What size chargers and where did you get that tight radius 180* on the cold pipe?
cumminsman315
New member
Looks like it's two 90s
Macktruckdriver
New member
Well I use to do 2 90s then finally found a tight 180 but didn't pay attention very well. Chargers are 60/68-.91 over 75/96-1.32 but may change to a 1.10. see how it runs first.
Last edited:
Macktruckdriver
New member
Getting the compounds on this week.
Macktruckdriver
New member
Also got some new wheels and tires.
Macktruckdriver
New member
Just waiting on my clamps to put the intake on. Took it for a quick spin. Lights fast but out of fuel by 35lbs :bang
Macktruckdriver
New member
60/68-.91 over 75/96-1.32
jlbayes
New member
Without the salty attitude. lol
Macktruckdriver
New member
Lol was giving me the slicks for it like giving her new boyfriend the underwear she left at your house :hehe:
zfaylor
Comp Diesel Sponsor
It was pretty greasy. LOL
Macktruckdriver
New member
Got Smoke?
New member
:drool1: sub'n
Highwayman
bored.
Also got some new wheels and tires.
That looks mean.
I have the same chargers, but with a lot of wastegate for the NAWSS. Let me know how you like them.
Got Smoke?
New member
Expected power #'s?
Macktruckdriver
New member
Enough to get me past 11.5s I hope. Then I'll need a cage and decide if I'm going to back half or not.