Recent content by 12valvetater

Does anyone have a throttle linkage for a ppump auto truck? I can trade a manual linkage if needed. Sent from my iPhone using Tapatalk

So I’ve been trying to find some information on switching a 2nd gen truck over to an aam 11.5 rear axle but either people aren’t doing it or no one is talking about it much. I recently bought a 97 roller with 60/70 axles in 3.55. I’m not much of a fan of Dana 70s and I have 60/80 axles in 4.10...

I am looking for the engine and transmission harness or just the transmission harness from a 96 or 97 with a 47re transmission. Thank you

Well after having my truck all these years I finally did it. Just a local 8000 pound street diesel class. I belive there may have been nine or ten trucks altogether and I managed a 3rd place pull. I managed 261 feet which was 6 feet behind second and 17ft behind first. The track always takes a...

Ever since I got my truck back from the shop after blowing the turbo it's seemed like it had a slightly lower idle speed than normal. It also felt like it had less power than I was expecting it to. I went from 181 delivery valves to 035s when the charger blew, so I don't really know what the...

I just put in a set of 035 delivery valves in my 160 pump. We made two good pulls on the road and pop went my Hx 40. Pumped pretty much all my oil into the intercooler and out the exhaust.I shut my engine down as soon as I noticed I had no oil pressure. Turns out the nut came off the shaft...

To run a 33/12.50 or a 305/70 would it be better to go with a 16x8 or a 16x10. I want the tire to wear more evenly than the 285s wore on my factory wheels. Also what backpacking and offset would I need I don't want them to stick out anymore than necessary.

I have a set of 215 injectors with about 4000 miles on them since being popped and one new nozzle installed. They are in great shape. Asking $250.

After rebuilding my engine the fuel mileage king of sucks. It's getting between 13.3 and 13.5 just about all the time. The pistons are .020 over industrial from an 0600 cpl that has been decrowned and also have 0.050" valve reliefs. The cam is a hamilton 188/220. 0.020" was taken off the deck an...

After almost four years I have my truck up and running again since dropping a valve. Ever sine I put it back together it has a pretty heavy gear growl when pulling through fourth gear. It only does it in fourth and only from 1600-1700 rpm. The harder you come through it the louder it gets. Could...

Pictures of Turbo

I have a wastegated hx52 for sale. It is brand new still in the bag. Asking 850 dollars.

Ive finally gotten my truck running after almost four years of sitting. Iut a fluids per on it due to the stocker being wasted but the tach doesn't work now. I hooked the sensor up with the wiring that came with the fluidamper, but the directions were pretty vague. Is the something I am missing...

My new engine has 380psi of compression when spun with a starter. It has .050" valve reliefs in 0600 cpl pistons that have been decrowned. It also has had .020" taken off the deck and has a .010" thicker head gasket. It has never fired so the rings aren't sealed 100%. Is there a formula I can...

I need a starter spacer for a 12 valve to run a twin disk.