Need some help with southbend hydros, driving yesterday and pushed in the pedal and it broke free from the firewall. Did some research and found that southbend made a new bracket to fix this problem. My hydros are roughly 5yrs old. How can I fix this, buy new hydro set up or can I replace the...
I really need a tone ring for a 01 cummins that goes on the cam gear. If you have the ring I will buy it, if you have the gear and ring I will buy it or if you have a complete gear and cam for a 01 I will buy it and I need it asap. Let me know!!!???
So I went to buy a new belt for the truck and it ran great. When I was leaving Cummins it started but then it shut off and kept shutting down every ten feet. I got it home and pulled P0341. So I pulled the sensor and the end was broken off. What could have caused this? Help please, I am...
Buddy of mine has a 6.0. EGR delete and cooler delete are his only mods. The truck starts fine then will start to make a knocking noise and blow black smoke from the exhaust. There is no CEL. What could it be?
I have a set of Wicked Diesel 240s and they run great and make good power. The only thing I dont like about them is that they haze pretty good at idle. Who could I send them to to get reworked and maybe make some adjustments to them?
Well after I installed my cam, the tach will only work for a few minutes. I am pretty sure the quad get its rpm reading from the same sensor. So my question is why does the tach fall to zero and the quad will still read RPMs? All I did was do a cam install and now this. I checked the wiring...
I have a set of Hamilton pushrods that I ran for about 10miles. The cam builder wanted me to use the stock ones so I have no need for them. Lookin to get $270
I installed a diesel pros killer b cam and everything went smooth on install. The engine turned over by hand just fine and started great. I also put hamilton push rods. Now the engine has a ticking noise and the noise gets louder with rpms. I changed back to the stock push rods and it still...
have an edge juice with attitude with hot unlock for a 2001 for sale. its been on the truck for about 5 months and want to go with a quad adr with pulse. askin 450
ok guys i am going from the manual to an auto. Is there any pointers that I should know about? also can you guys help me make a list of what I will need....
trans
transfer case
drive lines
crossmember
mounting bracket
lines
cooler
column
pedals
will I need a......
PCM
ECM
heat exchanger
what...