Recent content by grncummins

2007 stock truck. A couple weeks back truck started losing power and every few days would throw the 0088 code but cel would go away the next day. Even when the truck doesnt have the cel up it is still low on power. I pulled the plug off the fca while running and and you can definitly tell it...

probably a stupid question but searched and couldnt find the answer. Can you get 30 over mahle common rail pistons or just 20 and 40 over. thanks.

Billet ATS input shaft for sale. 2 piece. brand new never been installed. $675 shipped or best offer. thanks

let me know what you have. thanks prefer pm's

Would like to trade plus cash my smokem built 5x16 injectors for something bigger like 5x22's, 5x25's, etc.these injectors have about 30 min of run time on them and 1 pull just need to go bigger. Injectors run great. prefer pm's thanks.

Need a fluid dampner for a 12v cummins let me know what you have thanks. Prefer to be pm'ed

S-475 from force. fully built 2.8 motor with 13mm pump. to run with an external wastegate or without. Have had multiple people tell me to go without.

What are the most common causes of sticking a plunger in a 13mm pump?

Ok I have a Piers 13mm stupid pump and they dont have a timing chart for it and I desperately need one. I have the timing chart for Industrial Injections 13mm pumps and im wanting to know if I can use this chart, it would make it so much easier. If the quick rate cams in them is roughly the same...

I have what I think is a non wastegated Industrial injection K31. I believe it is a 71/74 with a .9 exhaust housing. I need a wastegated housing and waste gate assembly for this. Let me know what you have. Thanks

Pictures by grncummins - Photobucket This is a PDI T-4 Flange 3 piece manifold. Please look at the pics. This manifold has been cracked but welded up as you can see in the pics. I do not know if the manifold will leak or not, as I have not ran it. The manifold was welded and then coated with...

Ok I need the stock plates that go between the coil springs and the shock tower. I have a truck with a leveling kit on it and I want to take the leveling kit off, but need the stock plates to do this. let me know thanks.

ok bought a truck with a leveling kit and went to take it off and appears that there are stock plates that are needed is this true? I am completely unfamiliar with this. If the stock plates are needed does anyone have any they want to sell?

Ive done a little searching on here and have found a little info about it but it was a few years old. Im running electric fans and an electric water pump but still want to keep the alternator. So what belt length and what kind of routing are yall doing? Cause it doesnt appear like there is any...

Is it possible to gasket match a 24v round hole manifold to work on a 12v head? Wondering if anyone has done this and if there is enough material to port the 24v exhaust manifold and make the round holes somewhat match up on the square holed 12v head? I have a free 3 piece 24v manifold and would...