Recent content by LReiff

Dodge : Ram 3500 SLT in Dodge | eBay Motors

'97 12v short block, IH casting, includes block, rods, pistons, good for a rebuild - $850 '97 12v cylinder head from motor above, also IH casting, no cracks, loaded - $400 IH casting 12v block Has been line honed and has main caps with 14mm main bolts Has 14mm head bolt holes Has been decked...

9.25" Front axle with 3.73 gears and dually adapters - $550 11.5" Rear axle with LS and 3.73 gears - $850 Both are complete with brakes and springs, front has control arms and steering linkage.

Block is used/reconditioned, as described below. IH casting with 14mm main bolts drilled and tapped for 14mm head fasteners cleaned and magged - no cracks found line honed - std. decked - .005" cylinder bores honed - std. Ready for assembly. Asking $1500 obo. Serious enquires only, call or...

Thanks Lance!

All parts are off a running motor. ECM $250 Engine wire harness $150 Rocker box with injector harnesses $100 Rocker set with valve bridges $100 Prices above include shipping. Loaded cylinder head $650

Used Turbo For Sale - Unknown miles, minimal shaft play. Great overall condition. Tag reads P/N 2462359 Mod. HTB2 It's for a 3rd gen application. Has 3rd gen size turbine outlet and 90 degree comp outlet. Wheels measure 62/71, turbine housing should be 14cm, I'll verify that once it's off...

NV5600 from a 2005 truck. Has approx 50k miles on a rebuild. 271D from same truck, with output yoke. Asking $5000 for the combo. Will consider less if it's a cash offer. Will split if trans sells first. Text or call. 7l7-44O-82O7

What is the going rate to clean, pop test, and adjust/balance a set of VP-44 injectors to p-pump pop pressure?

Removed to go a different route. Work and look flawless. $1000 plus freight.

Only #7 cracked. Anyone else seen this? Injectors were new approx 50k miles ago.

Who has seen this code? What have you found to be the fix?

It's ugly but functional and hopefully in the long run it will save me a few Benjamins! LOL 1986 VW Scirocco with a 1.6 diesel swap! It still has the fuel pump in the tank and it works, diesels did not have a tank pump from factory! It has the larger "gas" exhaust!

I have a good used OEM main shaft that was removed from an NV4500 to upgrade to a full splined 5th gear. It would be great for a sled pulling trans where 5th is never used! Shaft only - $75 plus freight.

Anyone here familiar with the MD-TICS pumps? Variable timing and electronic governor problems.