I apologize for the questions ahead of time. I have set timing several times on a 12v ppump. It's been years since I have done this. I am helping a buddy swap a ppump onto a 24v. I have a snapon timing set.
My question is..... where is my reference point for the pump timing. There is no pin to...
97 185hp pump truck 5spd Brand new motor Marine pistons 28* timing O- ring head Compound hx35/ht60 Custom cut DVs. Close to full cut but not. Marine 370s Hx35 has a lot of WG work done to help with drive pressure.
My question is what is a good injector to put in place of the 370s? Im pretty...
I have searched different places and cant find a deffinite answer. Is anyone running a holley black successfully. I cant afford an airdog or fass setup right now but I need something. Will a holley black support me until I get the funds for an airdog or fass. All input is appreciated. thanks
Yesterday I hauled a 11000lb tractor on 4000lb gooseneck, I couldnt try hard enough to keep the egts below 1200*.
The truck has the mods listed in signature. The HT60 exhaust housing is a 26cm housing. Without a load the ht60 will start to make boost when the hx35 is at 6psi.
Yesterday it...
Okay Im having some problems and I dont know where to start. couple weeks ago i got in my truck started down the road everything was fine in all gears. roll up to a stop sign pull to neutral then the truck wont go into gear finally get in 5th so i put it in low and limp home. when i took the...
Okay I have been searching for a couple of days after the swap and I cant find anything. I have a 97 2500 4x4. The truck was an auto and I swapped the trans for a nv4500. I am still using the same np241 DLD transfer case. I plugged the connector back into the transfer case where it went...
I have a 97 2500 4x4 auto. tranny doesnt slip, I am wanting to change to a 5 or even a 6 spd. i would be willing to trade the auto and cash for manual parts. let me know thanks
I have a 97 2500 4x4 with a 47re automatic transmission. I was wondering if anyone has ever customized there own valve body. I know that when you buy an after market body you get a stock one that has been drilled and changed around. Is there a do it yourself kit where I can do all of these...