Recent content by WINspeed

I want to thank CL2000 for all your help with putting the new motor in my truck. I can't thank you enough Chad! You Da Man!! Friday I was putting the new motor together and searching for parts that were scattered all over the shop over the past 9 months (it turns in to the "Pick and Pull"...

It looks like I may be building a short block. Any suggestions on pistons? I do still drive my truck daily. What design will make the most power? I was thinking about running Cummins pistons, whats the best? I'm open to suggestions. Fire away! Thanks.

I'm Stoked!! We hit 1002 hp with my small injectors (6x12's) at Poncis event. This is the same exact setup I drive everyday. We can honestly say a daily driver VP set up can make over 1000. And there is still a lot of tuning to do. This is the first time running the bottle on the new...

If so will it do it past 3000 rpm?

Does anyone make one with over a 5000lb limit? All I can find is max 5000lb trailor weight.

Didn't matter though, the trans broke. LOL Well the truck is running good. Good enough to smoke another trans. On the first hard pass It started slipping and wouldn't shift into OD, It stopped making power just before the 1/8th. Here are the #'s! 60'-1.59 1/8-6.93 1/4-11.27 @ 109 3rd gear...

The first annual Paul Starzyk memorial dyno event! This event will be held in honor of Sgt. Paul Starzyk, of the Martinez police department. Paul was killed 9/6/08 while responding to an "active shooter" situation. Because of his heroic efforts and ultimate sacrafice, he saved the lives of...

Parting out 2002, 2500, 2wd Auto, Quad cab -------------------------------------------------------------------------------- The longblock is spoken for. Everything else must go. Suffered major driver side damage and a moderate front end hit. 2002, 2500, 2 wheel drive, short bed, Quad cab...

My cruise control wont set any higher than 85mph. Anyone know a fix for this? Other than programming the speedo so that it reads to low. With 33" tires it's now setting at 89 on GPS, but the speedo says 85. I like the extra MPH but I want to reprogram the speedo so it's correct.

Has anyone weighed the difference? Who's making the good ones? My experience with cars is that a few fit well and most don't.

Is there any RPM activated switches that will work on the diesels? Most I'm familiar with switches that use the negative signal from an ignition coil for a gas motor but haven't seen one for a diesel. I was talking to someone at the J&H event that said they had one from NX on there truck, But I...