Im completely parting out the 94 I have. The truck is bone stock with 200k on it. A guy owed me money but lost his job. He gave me this truck to part out in hopes to recoup some of that money. I do not know much about this truck except for that it ran and drove to my house and I started tearing...
I am struggling with an issue launching my truck and before I rip this converter back out to send to DTT, I would like to just plug in a smarty and make sure it isn't torque management. Can anyone in the area help me out for a few minutes? I am out of ideas other than this.
When I did my trans I bought the line that has the port for trans temp. My autometer temp sensor is 1/8 inch I believe but the port is much bigger. Can you help me out with what size brass fitting I can go pick up to reduce it down for the sensor? Tried searching but I couldn't come up with any...
Just put on the 66 and have done a few 10-15psi launches on the street with no issues and plenty of power. Loaded the truck up and hit the track. The first time at the line I wanted to take it easy and came off way under the turbo and it didn't light until I was far underway. I thought I might...
Right now my truck is lifted 4.5inches but I am dropping it down to stock with a leveling kit. I am currently running 35 inch mud tires but am going to replace the bald tires and pitted rims. I would like to stay with a 35 inch tall tire and run bfg allterains on a 17 inch rim. The problem is I...
I have a Fass lift pump but I dont remember it having any numbers on it to tell me which pump it is. It was on the truck when I bought it and I have never looked into figuring out which one it is. I am hoping it is the 150 but all I know is that it is red.
I am getting ready to throw a lot...
I have a lift on my truck and I am trying to set it back down to factory ride height. I would like to buy the factory front control arms. I would also like to see if I can pick up a Carli leveling kit used rather than buy one new. I have money ready to send.
I am looking for a decent set of 17 inch wheels with some 35 inch tall BFG All Terrains. I was originally looking at the Mickey Thompson Classic II's but I will entertain all ideas.
I hate to make another programer question but I am having issues deciding exactly which route to go.
First of all I have a Edge drag comp. It isnt fueling exactly right so I think I am going to have to send it back to get flashed for $150. Next year I would like to build a new engine and P pump...
I have a D70 with 4.10s in the truck right now. The first time I pulled the truck I grenaded the spider gears with a hard launch. I replaced the center section with an upgraded unit(I dont remember what it was called). I do not want to ruin a perfectly good rear end that I have already invested...
Right now I am putting together a fully billet unit with the DIY kit from DTT. When I ordered the parts from them I was told that I shouldn't use stock tranny lines due to the added pressure from this unit and the TQ would not be covered if a trans line failed and ran it dry. I have tried to do...
Hey, I am new around here as this is my first post. I am looking into buying/building a set of traction bars. My truck is a weekend street driven play toy that also get raced and pulled. I know a lot of high HP guys that drag race are buying the caltracs with good results and I know they work...