Search results

2006 dodge ram reg cab 2500 6spd 51,000 miles , truck dynoed 653hp and 1200tq, the truck has k&n cold air, ats 2 piece manifold , ats intake horn, 66,74,12 ed turbo, snow performance water meth kit wit 220 pump and 2 625lm nozzles, 90 hp injectors, hamilton 110lbs valve springs, apr head studs...

I have a hushpower 5 inch muffler on my truck I was wondering if I took it off, if it would help for better number on the dyno. 2nd question I put my truck in storage and went to start it the other day and found a oil leak on the oil filter and a coolant leak on the back passager side on the...

im looking in swapping my g56 out of my pulling truck and swapping it wit my duallys nv4500. does anyone actually know wat needs to be done for the swapp? does the bellhouse have to be swapped

this winter i plan on building an engine. I like to stay in the 2.6 class for pullin but the only question i have is should i put in a gridle and 12mm mains studs? im just wondering if its necessary bc i produce only 55 psi and the truck only runs at 4500 rpm going down the track.

i was looking into the dick cepek fc II for next year has anyone had any good luck with them pulling? but i wanted to try 34.4 for a little bit more speed and 13 for more grip. 325/65/18

my first pull of the year wit my truck and this is wat happend http://www.youtube.com/watch?v=EVrl0Irk8kE its slipped 100ft down the track and then grabbed i tried 5 gear low had 33 for tires and 2.6 turbo my clutch is a southbend 3600 any opinions and tips

Does anyone know the size of the front control arm joint?

has anyone swapped a cr trans (g56) for a 47rh?

Is it possible to do the swapp from a g56 to a nv45 ? Wat do I need to make the swap

hey i was wonder if ppl r using airbags for pullin and jw how they're making out with that setup. Also did u buy a direct kit say from air lift or just build your own.