05 Chevy Pulling/Street Truck Chassis +Mods

[PowerMax]

I've decided to go a different chassis route for my pulling truck. I am selling a complete truck minus engine, ecm, tcm, and intercooler. Everything else will go with chassis. Here are all the mods (that I can think of) that I have done to the truck. I may add other mods to this list as I think of them. Here are the details.

-05 Chevy 2500HD, 4x4, CC, SB.
-Less than 10,000 miles on chassis
-6" single stack
-37 spline axles/spool
-Front elocker
-3 link traction bar setup
-Steel driveshaft
-Driveshaft loops/u-joint shields
-SCIV Refreshed
-Billet input/output shaft
-ATS custom stall 5star converter
-ATS co-pilot
-10an fuel supply line
-Airdog 250 lift pump
-NOS wiring/plumbing
-Dsp2, dsp5, fuel pump, water injection switches
-Boost, pyro1, pyro2, rail psi, oil psi, water inj psi gauges.
-Choice of 35" Trxus or Mastercraft CT tires on 17" Hummer wheels
-Air and fuel shutoff
-Fully adjustable pulling hitch
-Front weight rack
-Complete wiring harness in tact for all modules

I'm pretty sure that covers it. As you can see, adding up the value on this list has to be $15K-$20K. Basically this truck chassis is ready to drop an engine and go pulling in pretty much any class out there. Feel free to ask any questions.

Asking $27,500.

Reasonable offers considered.

 

[PowerMax]

Bump

 

[PowerMax]

$24,500 obo.