12 valve Fluidampr tach pickup relocation.

[cstalnaker]

Am I a complete idiot or will the relocation bracket for the tack pickup that comes with a fluidampr not work on a 12v? I have tried this thing sideways, upside down, right side up, forward, backward, everything, and it doesn't fit anywhere in any of the front cover holes. I can't figure it out.

Thanks,

Craig

 

[CorneliusRox]

I know a few guys that did on 2nd gens and didnt have issues. Maybe the 1st gen kit is different and you got the wrong kit?

 

[Tate]

Lowest bolt replaces the one through the timing case to the block on the driver side, the other replaces a cover bolt.

 

[cstalnaker]

I got it figured out about twenty minutes ago but I still had to do a bit of grinding on the bracket because my pickup clearance was too tight. It worked out though.

 

[cstalnaker]

I tried flipping the bracket around but the clearance was way too large.

 

[12vfleet]

I didn't have any issues when installing mine. Just bolted on, plugged in and was ready to roll after getting the spacing correct.

 

[cstalnaker]

Yeahh, I probably made it a lot harder than it should've been. Idk... it's on now so I'm not going to worry about it. haha