12v + 24v Injectors

shortbusdriver

shortbusdriver

this guy
24v

7x.012" Bosch Sac 150°, .020" tip, new nozzles, new bosch bodies, opening pressure can be set to whatever you want. $700 or $650 with cores.

7x.010" Bosch Sac 150°, .015" tip, new nozzles, new bosch bodies, opening pressure can be set to whatever you want. $650 or $600 with cores.

7x.012" Bosch VCO 152°, .016" tip, new nozzles, used bodies, opening pressure can be set to whatever you want. $550 or $500 with cores.

Used 6x.013" Bosch Sac 160°, unknown miles, just gone through and set to 305 bar. $400 or $350 with cores. I also have some cut crossover tubes to allow the thin sealing washer. $100 plus cores on the tubes.

12v

Used 215 5x.010" Bosch vco. Unknown miles, just gone through and set to 270 bar. $150 or $100 with cores. I have a couple sets of these.
 
Since some need this to be pointed out, the 215 injectors were just gone through.

Will consider trades for a large single turbo, 17" or 18" rims, nitrous setup, 12v dampnr, borgensen power steering pump and lines (hydro boost), or a hogan ic.
 
I dont see results from the tubes. I make them for injectors with a wider pattern, or to run additional timing (with the thin washer). Once I send them out I never hear from them again.

These have the edge filters removed.
 
If he's selling them they're good stuff. Have some 5x14 SACs on the way from him. Love his 5x12s he currently made for me. Great guy bump.
 
Cheapest place ive seen the 7 hole sac with new bodies is over $100 more then what im asking.

Should have a set of new 12v 4x.015" 155° that I will prob throw on some 1st gen bodies.
 
You must log in or register to reply here.
Back
Top