ahale2772
New member
- Joined
- Oct 27, 2011
- Messages
- 2,442
Questions,
1 when are the axle shafts of my d60 going to break?
2 what shaft can I but that will eliminate the CAD with my stock 3.55 gears (guessing 30-31ish spline?) even if the CAD wont break, i'd rather just eliminate it. UNLESS, i have to go thru the BS of pulling the carrier to replace that iner seal if a 1 piece shaft requires a different seal
3 can I use a d70 1410 yoke to replace the 13whatever yoke that comes stock? I need to build a drive shaft to adapt to my np271 still, looking to build it 1410 so I can use 1 joint for the whole truck
thanks in advance
1 when are the axle shafts of my d60 going to break?
2 what shaft can I but that will eliminate the CAD with my stock 3.55 gears (guessing 30-31ish spline?) even if the CAD wont break, i'd rather just eliminate it. UNLESS, i have to go thru the BS of pulling the carrier to replace that iner seal if a 1 piece shaft requires a different seal
3 can I use a d70 1410 yoke to replace the 13whatever yoke that comes stock? I need to build a drive shaft to adapt to my np271 still, looking to build it 1410 so I can use 1 joint for the whole truck
thanks in advance