chris lang
New member
- Joined
- Jun 27, 2010
- Messages
- 843
Truck spun a bearing due to failed oil pick up tube gasket. Would still start and run, but kept her shut down
.040 over Teflon and ceramic coated Pistons. Look good, no scuffing.
12 valve peened and balanced rods. Probably need resized and rebalanced.
Scheid street and strip cam.
Crank probably needs a grind
Block already has a liner in #5. One of the cylinders is chipped at the bottom, I think I let a connecting rod fall on it during disassembly. Had .029 piston protrusion, ran a modified 12 valve.020 thicker gasket from Mumau. No problem holding 50 psi. Was told a marine gasket would work too, but havnt checked it out myself.
Comes with oil pan, oil pickup tube, stiffener, oil filter housing and oil cooler, rear main seal housing, timing case and cover, lifters, piston oil squirters.
Asking $700 as it sits, not going lower. Price is plus shipping.
.040 over Teflon and ceramic coated Pistons. Look good, no scuffing.
12 valve peened and balanced rods. Probably need resized and rebalanced.
Scheid street and strip cam.
Crank probably needs a grind
Block already has a liner in #5. One of the cylinders is chipped at the bottom, I think I let a connecting rod fall on it during disassembly. Had .029 piston protrusion, ran a modified 12 valve.020 thicker gasket from Mumau. No problem holding 50 psi. Was told a marine gasket would work too, but havnt checked it out myself.
Comes with oil pan, oil pickup tube, stiffener, oil filter housing and oil cooler, rear main seal housing, timing case and cover, lifters, piston oil squirters.
Asking $700 as it sits, not going lower. Price is plus shipping.
