91.5 Dodge cummins truggy $6000

revolutiondsl

revolutiondsl

Cat buys my Cummins parts
Joined
Jun 3, 2007
Messages
1,391
Engine runs very good, hood stack, DennyT fuel pin, injection pump rebuilt, factory 5 speed has been recently rebuilt, 205 transfer case, Dana 60 with chromoly shafts, Detroit tru track in the front, Dana 70 rear, 4.56 gears, 42/14/16 iroks, heat works great, doors come off easy, comes with a cobra 29 cb, fuel tank in the bed all gauges work and has an auto meter tach, pyro and boost gauge. Clean title in hand. Might trade for a 1st gen, 2nd gen dodge 4x4, 7.3 powerstroke or a gasser 3/4 ton 4x4 or a nice 4x4 quad.

699340B4-B474-4937-9857-04306CC06DED-12428-00000B65B1A26951_zpsefbfcece.jpg

672EFDD8-D4A1-4CA6-8D58-B488BA354981-12428-00000B6592ABF2DD_zpsafa45c34.jpg
 
Sure looks like a fun toy! Small enough to get in/ out if tight spots and torque to climb everything.
 
Ya it's a lot of fun and it's very reliable after I put good axles in the front and driveshafts I haven't broke anything other then a lockout. Lots of torque and uses hardly any fuel just putting around.
 
Nobody wants this thing. Nothing wrong with it just don't use it as much as I'd like to.
 
I didn't somebody else did. I wouldn't of been able to do it. I bought it pretty close to being running just fixed a few things and traded a jeep with out an engine. I wouldn't tear apart a nice first gen for a off road project that's what jeeps are for. They are worthless on the road
 
if I could actually FIT in it, I'd buy it in a heartbeat...

if it were a chopped down club cab or a ramcharger/trailduster, I'd be all over it.

but, alas, I simply do not fit in a reg cab 1st gen :(
 
If someone can give me 4000 tomorrow I'll sell it for that. I found a truck I want
 
You must log in or register to reply here.
Back
Top