After auto swap no backup lights

[danni's cummins]

I have a 48RE with PCS controller and all the other billet goodies:rockwoot: BUT...... no backup lights.

What has to be done to hook up the backup lights?

Is there something that has to be plugged/spliced in somewhere?

I could just run aux lights of a switch but lights that turned on automatic like they should sure would be handy.

Danni

 

[Jeff K]

I just sliced the Reverse sensor wire from the NV5600 into the Reverse wire of the Range Position switch on the Auto and it works like normal.

 

[danni's cummins]

Which wire do I splice into?

Closest to the tranny being number 1

[/IMG]

[/IMG]

 

[Jeff K]

Pin 6: P/N Sense

Pin 1: Power from Integrated Power Module for reverse lights (Br/LG)
Pin 4: Backup Lamp Feed (Vt/Bk)

What I did was find a transmission wiring harness and use that connector to splice into my existing wires from the NV5600. Hope that helps.