Do you have a setup for using 1 pump, like the fass 150/180???
Is there online instructions on install for 95 ram 2500?
so how much power is the airdog 150gph fuel filter pump system good fuel, will it support 6-700 hp? heres what i'll be running 180 pump: 0, or 10 plate, 4kgsk,Industrail injection dragon flows rated at 175hp, and probably an htt prostreet/sledpuller 66/71/13ss or maybe a silver bullet. im not sure yet, and there maybe .022 ddp delivery valves in there if i find i don't have enough fuel yet, and possibly nitrous to clean any extra fuel i do have.
Any questions or comments you have. Feel free to ask. I ask to please keep all AirDog vs. Fass arguements away from here. This is just for product information and/or tech questions. Thanks
Got a quick question, my AD150 in the last 2 weeks has gone from quite, you can barely hear it over the engine to LOUD, you can hear it over the engine and clutch chatter. Is this normal for these things to get louder with miles or is it one its way out?
I just got an airdog150 ordered for my 12 valve...and when I was talking to my friend, he heard from a fass dealer that the airdogs150's mounting is a lot lower to the ground than the fass150's units. IIRC airdogs are a lot smaller and compact. Is this correct?
to me this isnt a concern...I'm just trying to convince him to save the xtra $$ and get the airdog over the fass.
also, how does one get a 40psi spring that I have heard of before?? Thanks.
Anyone have any good tips for removing the filters? I think I have a vacuum leak (not sure were yet) and I wanted to make sure it wasn't the seal in the separator. I started to unscrew the filter and all it does is piss diesel everywhere. How about tips on finding vacuum leaks? The pump sounds like its cavitating........
I installed the Airdog 150 about three weeks ago on my 02 VP truck and Ive decided to go Ppump. Obviously the P7100 requires more than 15-20 lbs of fuel pressure soooo, What do I need to get the required PSI? The injection pump is a stock 913. I plan on using the stock overflow valve plumbed with -6 to the stock return at the back of the head. Hope that helps. Whats the set pressure that the 12V AD150's come set at? I hope I just need a spring.
Thanks for the help, Aaron.
Great product BTW....
I can't keep steady strong pressure with mine at all! I have been running it for 2 months now......sometimes it holds and most of the time it don't.
I have pulled all the fittings and resealed them and tightened the hech out of them...I am pretty positive I don't have an air leak. I have pulled the gear cover off and there is no scarring in the housing or rotor? It holds steady when it is cold but once I get to op. temp for awhile it will start to build and bounce again. It drops to 15 and slowly build up to around 18 then does it again or stays steady then starts or start bouncing all over the place without dropping past 15 lbs??
All electrical connections are good and have a new set of batts and get proper volts to the plug.........you have any help for me??
Thanks!!
Is The New High Volume High Pressure Unit Avialble Yet And If So How About A Part #