Broke front diff.

[Schevyii63]

Well today I gernaded my front spider gears. :bang I'm looking to spool the front diff. Does any place make a 4.11 30 spline spool, Or 35 spline inner axles with CAD?

 

[zstroken]

EMSOFFROAD has the 35spline one piece.

 

[Schevyii63]

If I ditch the CAD how will it steer on the street?

 

[Rollin Coal]

with a spool..... into a tree

 

[CL2000]

If you need front gears I have front and rear set of 410s forsale and a guy needs only the rears. Dont do a spool in the front

 

[GOT-Torque]

with a spool..... into a tree

:hehe: but very true...

 

[Schevyii63]

My ring and pinion are fine. I have 4.10's. So no spool, Even if I had the central axle disconnect working? I just hate to put stock parts back in and break it again.

 

[GOT-Torque]

With a CAD it would be ok (always turning the spool and front driveshaft though), without a CAD or lockout hubs it's darn near impossible to steer.

 

[Rollin Coal]

spooled in 4wd in the snow is a death wish also, i used to have to only lock one hub in my jeep, then it had torque steer LOL

 

[seeker1056]

yes - even a really good locker setup is death in the snow or rian lol

takes a hell of an arm even with power steering to run with one hub locked

 

[Rollin Coal]

yes, it was pretty bad lol.

you should look into an air locker

 

[Schevyii63]

I ordered a set of yukon spiders, I'll set the money elsewhere on the truck.