Crank Ventilation
- Thread starter TruckYou
- Start date
BigPapa
Truckless
- Joined
- Jan 25, 2008
- Messages
- 5,080
Then you already have #5, #6, and #9.
#'s 1, 3, and 7 aren't needed.
I'd say you'll also need a #11, 3903475.
So, your list will include:
I don't know what Snedge would sell these pieces for but my cost on them here at the shop would be just under $90 plus tax.
#'s 1, 3, and 7 aren't needed.
I'd say you'll also need a #11, 3903475.
So, your list will include:
- (1) 3944797 Crankcase Breather
- (1) 3680536 Tube Brace
- (1) 3903475 Rectangular Ring Seal
I don't know what Snedge would sell these pieces for but my cost on them here at the shop would be just under $90 plus tax.
Financial Mistake
New member
- Joined
- Apr 27, 2017
- Messages
- 278
^ would go with that vs what I have. You'd have to get a Vc with an oil fill cap if you did the cover like I have.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
TrailTamer
New member
- Joined
- Apr 6, 2011
- Messages
- 246
That price is astounding high. I bought my dual valve covers breather parts much cheaper than that from my local case dealer.
CorneliusRox
Seasoned Rookie
- Joined
- Dec 13, 2012
- Messages
- 4,154
I used to. The best bang for buck that I found was an EGR vacuum pump out of an early 2000's F150. It was $5 at a junk yard, 100% duty cycle, and will probably last forever with the relatively clean and cold air coming out of the crank vent (compared to exhaust gasses it was made for).