texastruck
New member
I just replaced my rear main seal. It wasn’t leaking, but I figured since the engine was out of the truck, might as well replace it.
The install was simple enough, but once I finished up and inspected the new seal, I noticed there was a small gap in between the crank and seal on the right side. Isn’t it supposed to be tight against the crank all the way around? Did I get a defective seal??
The install was simple enough, but once I finished up and inspected the new seal, I noticed there was a small gap in between the crank and seal on the right side. Isn’t it supposed to be tight against the crank all the way around? Did I get a defective seal??