Gravy
Giggity Giggity
- Joined
- Apr 24, 2006
- Messages
- 535
So I have been wanting a sandblaster for a while and I finally have a project to justify the purchase of one. The paint on my front Ranch Hand Bumper is peeling so I am wanting to spray it with Raptor Liner to match my rear bumper. With all the nooks, crannies, and expanded metal grille insert, It would be too much of a pain to do it with a grinder and sand paper. So, I am looking at 50-100lb pot sand blasters. I am looking at the Eastwood and Northern tool blasters. I will not be using this on a very consistent basis(once a quarter???) so I cant justify a ton of money on it, but I dont want something that is going to break after one use. I am trying ro stay under the $150-$200 price point.
Also, What do you guys recommend for a good drying system off my compressor? I should point out that I have an 80 gallon 2 stage compressor that holds 14.1 cfm @ 100 psi so air is not a concern.
Thanks for your help guys.
Also, What do you guys recommend for a good drying system off my compressor? I should point out that I have an 80 gallon 2 stage compressor that holds 14.1 cfm @ 100 psi so air is not a concern.
Thanks for your help guys.