HT60 wheel damage what to do?

[97singlecab]

I recently bought an HT60 for dirt cheap and when I took it apart to check it out I found the exhaust wheel has some small nicks taken out of the wheel.

Its pretty spendy to get a new exhaust wheel and shaft compared to what I payed for it. Do you think it will survive with this damage or should I get it rebuilt?

 

[97singlecab]

Anyone

 

[Big Blue24]

Run it and see. If a rebuilt will cost 3-400 and you can buy a barely used one for 3-400, what harm is there in running it? A scattered exhaust wheel will all end up down the exhaust pipe.

 

[97' CTD]

If their are no cracks I would run it....
Brandon

 

[roachie]

Are you sure its a 60? Looks like a 3b compressor in the background?

 

[97' CTD]

Are you sure its a 60? Looks like a 3b compressor in the background?

IIRC HT60 and 3B's flow no more air than the HSG's hair drying device.......
Brandon

 

[roachie]

IIRC HT60 and 3B's flow no more air than the HSG's hair drying device.......
Brandon

That's a damn lie and you know it.

 

[LReiff]

That's a damn lie and you know it.

I hope you missed the no like I did the first time I read it! LOL

Are you sure its a 60? Looks like a 3b compressor in the background?

That is a HT3B comp cover in the picture, but it's also on a cartridge....

 

[roachie]

In that case I retract me previous post. :bang

 

[97singlecab]

It is a HT60. My 3b is just sitting behind it in the picture. I'm gonna clean all the soot off it and if it doesn't have any cracks i'll probably try it.