I have an Isspro EV trans temp gauge.
The wiring for the temp probe is going to be a bit short to put the probe in the pan. Id rather not use the little alum deal with the hose clamp in the cooler line.
My ATS pan has the port for the sending unit already in it.
Will it affect the gauge at all if I cut and solder in an extension to the harness inbetween the probe and the little control box ?
The wiring for the temp probe is going to be a bit short to put the probe in the pan. Id rather not use the little alum deal with the hose clamp in the cooler line.
My ATS pan has the port for the sending unit already in it.
Will it affect the gauge at all if I cut and solder in an extension to the harness inbetween the probe and the little control box ?